Modifications

[barrywrx]

Got a clio 1.2 clio mk2 ph2 and looking for modifications that ii can do and what backbox sounds the best as ii have a cobra backbox atm but fancy something louder and a different tone oh and anyone tell me how too de-wipre it ? cheers

 

[colesy]

I think the general concensus will be don't bother and wait until you can afford something more than a 1.2.

 

[joshclio999]

youyou can de-wiper it by undoing the nut and pulling, then take motor out inside boot lid by undoing the torx bit and pulling off cover, undo 3 nuts, take motor off, replace cover. Simples. then just get a gromit to fill the hole. And depends what sound youyou want and the look youyou are going for.

 

[colesy]

 

[colesy]

That's mine before I sold it with my 172

 

[barrywrx]

I think the general concensus will be don't bother and wait until you can afford something more than a 1.2.

Yeah ii think so mate but just want mods too make it a little better untill ii can afford a buigger engine

 

[.Adam.]

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii

 

[barrywrx]

youyou can de-wiper it by undoing the nut and pulling, then take motor out inside boot lid by undoing the torx bit and pulling off cover, undo 3 nuts, take motor off, replace cover. Simples. then just get a gromit to fill the hole. And depends what sound youyou want and the look youyou are going for.

Cheers mate al give that a go and looking for a single tip and dono what sounds tbh a loud/powerfull sounds and that will pop on a standstill haha if its possible with a 1.2, my current backbox is a twin pipe with the buumber cut out how would ii get round that problem when gettin a single tip ?

 

[barrywrx]

View attachment 66872

Thats nicwe mate

 

[joe18two]

Some nice spelling there mate

 

[Knuckles]

this wont end well but theres a guide for dewipering the rear... you need two wrenches ( wrenches? )

 

[scott.p]

Cheers mate al give that a go and looking for a single tip and dono what sounds tbh a loud/powerfull sounds and that will pop on a standstill haha if its possible with a 1.2, my current backbox is a twin pipe with the buumber cut out how would ii get round that problem when gettin a single tip ?

If the bumper is cut for the twin exhaust then putting a single one on will look terrible unless you replace the bumper.
for a 1.2 dont try to make it sound like something it isnt, personally I would go the low and slow route.
btw stay away from the lexus lights and morettes

 

[otski172]

As said above its a 1.2 so no turbo badges or v6 badges like these halford tuners fit. mods u should do if any : lower, decent alloys clio cup or trophy, cup spoiler. and tints and thats it, otherwise it will look like mcdonalds car park jobby.

 

[Martyn-172]

If u want to go down the rep route then firsts must be RS grille, rear RS bumper, colour code side strips, 172 alloys! If your budget allows u then get some xenon headlights and 172 front bumper 2 suit then blank the washers, as for dewipering its a doddle, after u take the blade off unscrew the nut that holds the arm on (13 mm i think) open boot take of trim/cover then get a flat head screwdriver and i think its a 10 mm ring spanner! Put spanner over the nut then slot screwdriver into bottom of the screw thread ( its ther in your face lol) and unscrew the nut!! No need for 2 wrenches! After all is slack then unclip electric connections and your done