Rear allignment

[Keith185]

Can any improvements be done in the rear allignment on a Clio?

Front is setup at -1.5 deg camber.

with rear at -1.3deg camber (no shims) with approx 10 min toe in.

Or can anyone recomend a good setup that would be decent for both road/track keeping in mind that front camber will be no more than -2deg if I can get the extra 0.5deg on the camber.

 

[Gardus]

I have -1deg camber and 0 toe with shims, car is pretty reactive with the rear the helps in the corner.

 

[Fred@BTM]

i run toe out on the rear, hello sideways

 

[Keith185]

i run toe out on the rear, hello sideways

What sort of figures are we looking at with toe on the rear? Without making it too tail happy but giving slightly better turn in? (Rough numbers)

 

[Gardus]

I'd have 0~2 mm each side...it could be too much of a handful in the wet with more, especially if you leave too much camber.

 

[Jay Payne]

0.5mm washers under the lower rear hub bolts will give you about another 30mins of camber (half degree) but leave the toe as is.

we run aound 3 deg camber and a little toe out

No need for fancy shims imo. ours hasnt altered or caused any trouble

 

[Keith185]

Thanks guys.

Made mistake in original post last allignment checked it had 10 min toe out, so thats about ideal?

 

[Gardus]

Spot on for track but on the road I find it a bit too much.