Rear disk, Spacer/ shim

[rich-6]

Ok Searched, Gone through 8 pages, Found a few nice project threads now nackered lol

I'l be doing my brakes tomorrow one thing thats got me a bit iffy is the spacer that sits up to the bearing to stop the ABS rings fouling???

I've not had a disk off yet so dont know what it looks like but the spacer has a chamfered edge apparantly from what i read on here. If it happens to fall of without me seeing which is the correct way to fit it, Could someone tell me so i dont tighten it up the wrong way round and crack it.

I'm sure its pretty self explanitory when the disk is off but a few people seem to have had problems.

Ta

 

[DannoTheGreat]

you'll know when you put it against the disk buddy. The flat end will go against the bearing

 

[rich-6]

you'll know when you put it against the disk buddy. The flat end will go against the bearing

Cheers mate, Literally just found it on a .pdf doc Chamfered edge goes towards the car as you say