I've got a K-tec Stealth MK2 fitted to my Cup, haven't had any of the problems of it showing from the rear that others have but do have a question about visibility of it further up the car.
I've have new rubber mounts so I know they are good and in general I'm happy it's been well fitted, however the exhaust sags slightly where the k-tec mounts onto the cat - is this normal?
No pics at the moment, but I wondered if the spring encircled bolts could be the culprits, i.e. not tight enough (they don't look cracked) - are these springs partly responsible for keeping the exhaust pointing straight towards the back of the car (i.e. parallel with the floor of the car) or is that all down to the rubber mounts?
Thanks
p.s. I don't think this has anything to do with it being a k-tec exhaust, it looks as though it would sit in the same way regardless of the system because it's the cat which is pointing downwards to begin with
I've have new rubber mounts so I know they are good and in general I'm happy it's been well fitted, however the exhaust sags slightly where the k-tec mounts onto the cat - is this normal?
No pics at the moment, but I wondered if the spring encircled bolts could be the culprits, i.e. not tight enough (they don't look cracked) - are these springs partly responsible for keeping the exhaust pointing straight towards the back of the car (i.e. parallel with the floor of the car) or is that all down to the rubber mounts?
Thanks
p.s. I don't think this has anything to do with it being a k-tec exhaust, it looks as though it would sit in the same way regardless of the system because it's the cat which is pointing downwards to begin with
Last edited:
