Student MX5 track project.

[sbridgey]

Only picture I got at bedford.

IMG_1044 by sbridgey, on Flickr

So post trackday I had a few things to do, the aux belt had been squeaking for a while so I decided to check it out and see if I could figure out why.

Spotted that it was fitted incorrectly, this was after a specialist changed the cambelt too! Shocking.

IMG_1062 by sbridgey, on Flickr

This meant the inner ridge of the belt was a bit worn.

IMG_1066 by sbridgey, on Flickr

But I reset it and re-tensioned and low and behold no more squeak!

I managed to run over some grass on track and it had got caught and knocked my exhaust hanger (Cable tie) off.

IMG_1075 by sbridgey, on Flickr

I also raised the rear a bit as it had been scrubbing on hard cornering I think, it also looks better.

No pics of that though unfortunately.

 

[sbridgey]

Few pictures from Bedford.

140215_BA_Cars_SB0324 by sbridgey, on Flickr

140215_BA_Cars_SB0495 by sbridgey, on Flickr

140215_BA_Cars_SB1390 by sbridgey, on Flickr

140215_BA_Cars_SB2365 by sbridgey, on Flickr

140215_BA_Cars_SB2520 by sbridgey, on Flickr

 

[George@RTR_Parts]

Looking good Si, GoPro mount doing it's job nicely

 

[sbridgey]

Finally got round to fitting my offset number plate, i think it makes the front end look much better

IMG_1638 by sbridgey, on Flickr

Now its due a bath tomorrow!