Recent content by Anders

Best way is to have an AV reciever or matrix switcher in the mix too, that way you can feed all your sources to that and then just have 1 or 2 cables feeding your TV. If you are gonna dig out your wall then I would put in there either an RS232 or Ethernet cable. All devices will be...

Ah BALL$...didn't even know stuff like that existed here!!! Cracking pics.. and there I was chopping wood for the coming year, when I could of been..... CRAP. any other shows happening here at all? Heard there was a French Car Show in Tampere sometime in the summer.

400 Willy 1's aprox 2500 Willy 2's and by the time the Willy 3's were released, everbody was bored and nobody bought them. Not sure on the exact number of units produced though

Ah crap soz mate...you'll be on yer way by now then. Hope everything is OK. Another way to check dodgy gearbox bearings is to drop the oil from it. The sump plug on the gearbox is magnetic and will have the tiny swarf bits attached to it if the bearing races are wearing away. Sure you need...

For the aerial you just have to make sure the bolt is tightend properly. However resealing the sunroof is a slightly tricker job. The headlining of the car needs to be pulled back to access the retaining bolts, and normally the headlining is fixed with silicon adhesive in strips going across...

Nick, I remeber chatting to you right before you started doing these kits as you were complaining about the set up cost of the jigs!! Had to go Samco as you were doing them yet. Personally I think you could lose a few stickers from them though.. a little in yer face for me. Next time...I...

Could be anything mate, wheel bearings are fairly common to go. Next time you hear the nosie just gently swerve side to side and see if the noise changes pitch or gets worse if one direction. Easy and cheap to fix. If the gearbox bearings are going then the noise will only be evident - at...

No offence to Nick, but I would stick to the Samco hoses. Quality name, quality product. nuff said

It depends on which pulley has broken, there is two attached to the crankshaft. One is the main toothed pulley that is part of the engine timing. The other is just a normal flat pulley that spins your auxillary belt. Depends on which one has broken to the importance of it needing changing. If...

Try this... Get a suitable sized socket which you dont care about. Place over the knackerd bolt and smack it as hard as you can. This will deform the head into the hex shape and allow undoing as normal. Works for crappy rounded off wheel nuts..might work on your dilemma too

Just had my gearbox rebuilt also - for the second time!! Bearings went, but you could hear a grinding sound that worsened either on full load or lift off. I.e. When the transmission goes from one extreme to the other and the shaft running through the bearing flexs. Try draining your gearbox...

Yeah, forgot to mention the suspension. Although I didnt want to change the ride height as most of the roads where I will be living are gravel aka 1000 Lakes Rally and didnt want the expense of fully adjustables..so got all new units from Renault, plus new bushes on wishbones from Powerflex...

Hi there everybody...havnt been in this place for a long time... Anyways, I am currently preparing my Williams for export, as I am moving to live in Finland in Dec. As I have the engine and gearbox out of the car I was wondering if any other bits would be good to change at this point -...

Horrible, horrible cars!! Had one for about a week, got rid cause it was crap. The chassis was weak, suspension crap, the engine underpowered (for what it could of been), and the brakes are un-servoed. The only good thing was the gulwing doors.

Not much help, I know but I did it myself, dead easy. Just a good toolbox, socket set and a pair of axle stands. About £130 for the clutch kit.