Search results

Yep will clean it up but going to order one anyway as its definitely seen better days and as you say its cheap enough.

Looks like we may have a winner! Sensor looks a bit damp shall we say!!

Cheers all, will take a look when I get time must say it looks more red in the pic than in person.

Afternoon guys n gals I've just noticed my first oil leak! Yep been quite lucky!! Question is where is the most likely place it's coming from? Just thought I'd ask before I start to get down and dirty with it. I noticed a few drips on the drive but I reckon the undertray has caught a bit...

Quick boring one guys but anyone recommend any? I know I should get the official ones etc etc but really struggling to justify 65 squid! Tia.

I've just replaced my front two with the much maligned Zv7's! I was running Rainsports which were OK.

Nope!

Afternoon all, Can anybody shed any light on this one as I couldn't understand why the tester mentioned this. I thought rear brakes (discs) were self adjusting? I could understand if it were drums but on his machine the rears were showing 150 or something compared to other cars over 200, said...

Update. Cheers lads, battery has sorted it thank the lord! Now how do you delete threads :LOL:

No not yet, will give that a try later and report back, not my finest hour I must say ! :oops: Cheers lads for the replies.

Bump! I need to switch this off as I've the Mot on Wed! Or will it pass with it constantly on @ 100mph lol!!

Hi all, Slightly embarrassing one this, I was testing a few bits and did a wiper high speed test and it's not switched it off even after disconnecting clip and switching the engine off! It's constantly on full speed!! any ideas how turn the commend off?? TIA.

Anyone know a decent cable to replace it with. Seat won't tilt forward and I've replaced the cable with a bike gear/brake wire a few times over the last year but it always fails, so annoying. Ta.

I know you've sorted everything now but that bit is what happened to us, I was pulling my hair out effing and jeffing trying to sort it. I sorted in the end by hooking up my laptop to a bigger monitor to see the bottom of the screen!

I had a P0130 fault code and went and bought a new Bosch Lambda but before I went to fit it I drove it for an hour on the motorway to ironically pick up a 22mm sensor socket only to them find the EML light went off on its own! Mpg seems a tad lower though, was getting 30mpg and it's dropped to...

Cheers lads, will see how I go tomorrow with it, I'll be sure to give it a thrashing ;) Is the sensor or wiring anywhere near the brake fluid bottle? I only ask because when I spilt some it went down near the manifold and it was smoking a bit down there! I did obviously turn the engine off...

Here we go, cleared it and it's gone off however not sure if it will stay off. Didn't think so, I did spill some brake fluid from the Reservoir and ran the engine before I noticed, maybe fried something??

Pedal is firm now so happy But engine management light is on now wheres it wasn't before, brake fluid is above the max slightly could that cause it? One issue after another!

Eezibleed, will try again with it along with a few pumps of the pedal for good measure I've seen it mentioned some people have done it with the engine running and that's sorted it after forever struggling. Will give them a go before the local garage visit with tail between the legs.

Results are in... and it's a big fat fail (n) Bled it and surprisingly no air bubble out came out, gutted. I shall rebleed them all again starting at the rear, i tried the Renault recommended order and it's hasn't done the job. Pedal feels great when the engines off lol!

Hoping so mate, will post back tomorrow to see if the chase is on.

Update. All fitted and was very easy tbh, however the pedal travel is still the same :( Now I've bled 3 wheels however i couldn't do the OSF due to an issue with the locking wheel nut which I've just managed to undo. Question is, could this one side that I've not bled be the cause for the...

Sorted.

Any ideas on how to get it off? No problem with 3 of them but the drivers side front is just slipping off.

Arrived today so very happy with the service too, looks like this Josh lad is a good fella (y) All i need are fitting instructions now as they weren't in the box, mark them down on that 😆

I did have second thoughts ordering when I did a search on here! It's been posted so good start I suppose!!

Paul was one! No doubt he'll probably get back to us but i couldn't hang around unfortunately as i need the car back running asap.

OK now they are ordered is it worth getting a flared 11mm spanner or will a bog standard 11mm do the job?

Diamond mate, ordered.

James where from? I've messaged a couple of people on here but not heard back, needs sorting ASAP