Search results

7.4 hours

Why do people always think they need a new engine? Most of the time you can get away with a few new valves. Get a haynes and get the head off. Its a good job on them.

What ali said, if its got play in it, I fail it. Simple as.

Nooooooo! Not UKE. Had some fun in that car :)

Its the alarm unit I would imagine. Try unplugging it. Its under the passengers side of the scuttle panel.

Drivers rear inertia reel. Unusual to have a problem with that though iv never seen that fault before on a clio 2.

I love it on this site, you give people advise and they dont listen or take it in at all...

100% clutch. And it will get worse.

Ali hit it on the head there.

The horn is earthed through the braket its mounted on. Remove it and clean the area it bolts to the chassis.

Unless the misfire is only on start up, theres a slim chance it will be the glowplugs.

No they wont, all you will get is a new set with different locks. In the front page of your service book there will be a nut stamp with a number. You can get them to fit your car with that number.

Id imagine so, there all the same mount.

Yup, sammoose alrite

Diesels dont have plugs. Unplug the injectors one by one to isolate which cylinder is missing. Could be injector or a commpression problem. Yes it has the 16 pin diag socket under the ashtray and your fault reader should read the fault codes.

http://www.k-tecracing.com/show_product.asp?id=2471&pic=2 £17.63

Seat position switch

Mine was the heavyest iv ever seen. Replaced mine today, very very light now.

Cheating with your mates in your boot to make it look lower there mate. Looks good otherwise!

When you do put the new shim and circlip in it might not stay in for long. Normally its new box time.

Nearside front INNER ball joint = coaxial joint.

If it was the track rod end it would say track rod end. The piece they are talking about is the link from the trackrod end to the rack. In renault terms its called a Co axial joint. :)

Its not a service reminder, there might be another light on, maybe the airbag light?

I cant remember what you want doing again? Remind!?

May of been me in the ph1, go to and from dawlish a fair bit!

Small world!

Yes the stop light is normal when the handbrake is on. (someone will dissagree with me though) The SERV light only ever comes on with another light. Is the airbag light on?

f**k raising it up, sort the exhaust out 1st.

There isnt a thread in the bracket? It just slides in and nuts tight from underneath.

Iv seen this a few times now, get the braket off the gearbox and that stud is nutted from uderneath. The stud is around £12 iirc.