Search results

I used to have a set of wiring diagrams for my 172 cup, but cannot find them anywhere, does anybody have a copy they could email to me please?

Has any body fitted a ph1 throttle body & inlet to a ph2 (172 cup)? How did you wire the iscv & the tps? I have a me221ecu (which does not like idling with the drive by wire)

I have a throttle pedal track 1 fault which it putting the centre orange coil light on on the dash, is the white multi plug at the base of the engine fuse box wher the car loom joins the ecu loom for the drive by wire. I changed my engine loom at the weekend & this fault has came up since

Has anyone fitted a walbro fuel pump kit to their ph2 172? mine did not come with instructions, is it easy enough?

Can anybody help me please? I had a massive misfire at the last round of sls, before hand the car would not idle, after the misfire it would not start. It seemed to be flooding its self, got it home & had a look at my wiring for the motec piggy back ecu (fitted ready for future mods & to get the...

When fitting an omex ecu do both your standard & omex ecu need a water temp sensor? If the do do you just drill & tap the m12x1.5 hole into the housing or do I need to weld a boss on first?

On my clio 172 cup track car I have removed all my airbags, fitted resistors to all of the plugs inclluding the pre tensioners but the lights would go out then come on again after a few seconds, so today I took the airbag ecu out too & now the lights just stay on all the time. How can I get...

If I remove the air bag ecu will the dash light come on?

has any one bought the clip diagnostics units from ebay & were they any use? I i want to switch my air bag light off.

My original oil pressure switch has been removed & a dual temp & pressure block has been fitted in its place. Now I think the cable has just been left disconnected, if so does that mean my oil light would not come on? Everything seems to work fine no lights on on the dash!!

I have heard it is not a good idea to skim them, where is cheapest to get a new one if I need it? Its s mk2 172 cup.

i am away to replace my gearbox with a new one with a gripper diff & lower final drive, if I do need a new clutch which one do you guys recommend? Its a mk2 172 cup, catcams (438) will be mapped with a stand alone ecu, de cat miltek & has a pipercross air filter. May go down the route of either...

how difficult a job is it to swap a gearbox on my mk2 172 cup. Are there any hints/tips & special tools required. I do not have a ramp it will be on axle stands. Thanks

I am trying to wire my standard throttle body to a stand alone ecu, what cables should I be using, ecu need ground, supply & signal

Can you program your ecu to tell it you have no airbags fitted to stop the air bag/serv lights coming on?

Has anyone removed the passenger air bag & where do you connect the resistors?

Does anyone have the ecu pinout diagrams for my mk2 clio 172 please

I want to fit a digital dash with my new ecu, if I un plug the standard dash clocks, will this cause running issues with the car, it is a track car only

is it true that you can disconnect the dephaser if you have changed your cams?

Can you get rid of your standard ecu & just have an omex or motec to work the engine, with a digital dash

I have a 172 cup, can anyone tell me what the canbus actually connect too please?

Does anyone know where I can access wiring diagrams for my 172 cup, looking for engine, canbus & general wiring please

Can some one give me advice on the following please? I have a motec ecu left from my subaru which I want to use on my clio 172 cup. I have sourced the required plugs, but would like to know what all should the motec ecu control? Once you take the existing wiring out can you cut & disconnect...

Can some one give me advice on the following please? I have a motec ecu left from my subaru which I want to use on my clio 172 cup. I have sourced the required plugs, but would like to know what all should the motec ecu control? Once you take the existing wiring out can you cut & disconnect from...

I am looking to put throttle bodies on my 172 cup, is it a mk1 pedal I use & does it fit straight on?

I have just got myself a clio 172 (2002) how do you replace the power steering fluid? & am I right in saying you need a dexron 11 fluid?

my clutch cable end comes of the fork very easily, is this normal? Can I tighten it? Or is it time for a new cable?

Has anyone got any tips on how to set up a PMS shifter kit? I did mine tonight but just want to know if you can fine tune them or is it once you have all hears that is it?

can anyone tell me the size of the pipe that fits on to the fuel rail please? I need to fit a fuel sample kit but I am unsure of the pipe size.

I am new to the clio scene & some of my questions might seem silly but I am going to ask any way. I want to build a track/sprint car & would like to know if there is any difference between a. 182 shell & a basic two door model? I am stripping it all out anyway & only fitting the essentials after...