I have a phase 2 172 and have fitted a 182 engine and gearbox, problem is the 182 takes it's speedo signal from abs and the 172 takes it from a speedo drive on the box. I have a full 182 donar car so have plenty of bits to work with.
Questions are as follows,
can i get away with changing to the 182 abs pump and engine bay wiring so achieve the corect signal and still run the 172 ecu/uch etc?
or
will i have to change the complete loom from the 182 and ecu etc from that car, and thus doing away with the problem completely.
Does anyone have any suggestions or could someone help shed some light on this situation!!
I have no access to autodata so not sure on wiring at this point.
thanks.
Questions are as follows,
can i get away with changing to the 182 abs pump and engine bay wiring so achieve the corect signal and still run the 172 ecu/uch etc?
or
will i have to change the complete loom from the 182 and ecu etc from that car, and thus doing away with the problem completely.
Does anyone have any suggestions or could someone help shed some light on this situation!!
I have no access to autodata so not sure on wiring at this point.
thanks.