182 Power Question.

[Joeh90]

Hello All,

Had my 182 for almost 2 months now. It came with a Milltek Cat back exhaust, matched top and bottom inlets and ptfe gaskets. I had a K-tec induction kit fitted and a remap done. It gave the following on the dyno (I know RR's aren't the most accurate creation!)

186.4 BHP
168.6 LB/FT Torque

Is that about right for the mods carried out on average? I have had a de-cat fitted since the RR was done. I am happy with the figures for sure and the power delivery seems very smooth. Considering doing the cam's and then ITB's as the next stage in progression.

Cheers! Joe

 

[bozothenutter]

If you assume that they start out with about 180hp....then yeah that seems about right.
However the absolute numbers seem very high...or you kust have one of those freak engines

 

[Cub.]

Which RR?

Unless you have a freak engine (they do appear occasionally) then I'd say it's on the high side.

 

[LeeRS]

I went on an rr recently and got 193 ATF in a 172.
waste of my money to get a bs reading.
I thought ktec map was a baddie?

 

[STEVE.M]

Hello All,

Had my 182 for almost 2 months now. It came with a Milltek Cat back exhaust, matched top and bottom inlets and ptfe gaskets. I had a K-tec induction kit fitted and a remap done. It gave the following on the dyno (I know RR's aren't the most accurate creation!)

186.4 BHP
168.6 LB/FT Torque

Is that about right for the mods carried out on average? I have had a de-cat fitted since the RR was done. I am happy with the figures for sure and the power delivery seems very smooth. Considering doing the cam's and then ITB's as the next stage in progression.

Cheers! Joe

Impressiive figures,but can you lay it down,stop it and corner,better than some 90 bhp PSA product in the hands of an expert at Donington?