Amp power cable - 182

[phil_white16]

Hi sorry I'm sure loads of people have asked this question before, but I've been trying to find a grommet to feed the power cable through but just can't seem to find a place. Where have other 182 owners put theres?Thanks

 

[jamesy]

is there not one in the top corner of the passenger footwell?

 

[Jaffa182]

Theres 1 that the bonet catch goes throu its a rite b*****d to get 2 awsell. Took me bout half hour just to get the wire throu lol.

Jaff

 

[ALY]

If you've anything bigger than 8awg then you're going to have to put a new hole in your bulkhead. If you're carefull, you can go from the passenger footwell, drivers side of it, clean in to engine bay just on the drivers side of the brake pipes. Have someone hold a protective panel of some sort down between the brake lines and the bulkhead just in case you end up too far over and the drill bit goes further than you'd like...

 

[phil_white16]

thanks

 

[bmh.01]

I've squeezed 4awg through the bonnet released grommet no problems, took a good half hour of brute force and ignorance though but I got there. Just so you know its possible.
Would have been easier if i'd lubed it up with fairy liquid or something.

 

[The Bear]

I've squeezed 4awg through the bonnet released grommet no problems, took a good half hour of brute force and ignorance though but I got there. Just so you know its possible.
Would have been easier if i'd lubed it up with fairy liquid or something.

That's a good idea about the fairy liquid.