Clio II 1.2 16V Limp Mode Problem

[O.T.S.S]

Hi guys,

I know they're a few topics about this but I don't know which direction to in head.

Basically I've got a 2002 Clio 1.2 16V Dyn and it seems as though this is becoming a common fault with clios as they age, I have got the Limp mode problem and I have changed the Throttle body and Pedal, on both occasions the problem went away for a few days or so but it keeps on persisting the only soultions I have been hearing is to change the Wiring Loom but am I going to have to change the whole Loom or is it Pedal through to throttle body?

I have two photos of fault codes if this makes sense to anyone, any help or advice would be much appreciated.




[img=http://img51.imageshack.us/img51/9394/img0733k.th.png]
[img=http://img100.imageshack.us/img100/9455/img0732.th.png]

 

[MicKPM]

There was an OTS on this back in 2002... micro breaks in the cabin loom and there's a specific loom section to buy that runs from the pedal direct to the white plug "R65" in the engine bay fuse box. Have you checked the resistance values on tracks 1 and 2 to see if they're okay?

Mick

 

[O.T.S.S]

Thanks for the advice Mick, I'll give it a check over, is this the cabin loom that you were on about?

http://www.ebay.co.uk/itm/Renault-C...arts_Vehicles_CarParts_SM&hash=item519bddb02b

 

[MicKPM]

Thats similar looking but not the correct part number on the OTS.... that might be for a vehicle with ESP though and without checking the part number against a vehicle I couldn't say for sure.

Mick

 

[O.T.S.S]

Okay thanks Mick, much appreciated.