Does anyone have a picture of how the inlet seal should sit?

[jon_r]

As above. I think the seal should go flush against the face of the head/rocker cover before fitting the dephaser pulley, has anybody got a picture of it all? I don't want to screw it up a second time as it's been an expensive mistake this. :dapprove:

..assuming the exhaust seal sits flush as well?

 

[mark123]

Exhaust is flush inlet is pushed in a bit isn't it?

 

[jon_r]

This is why i'm after a picture as everyone says something slightly different. We pushed the last one in too far and have a leak.

 

[mr.pink87]

Flush.

 

[Dan519]

Both sit near enough flush, in by 1mm wont hurt as long as it's even and straight

 

[jon_r]

And flat edge facing the head or the pulley? (exhaust and inlet?)

Thanks guys. I bought some non genuine seals, but felt dirty, so i've ordered the genuine kit again. Sigh.

 

[Dan519]

Flat side outwards