Fitted Megane Splitter! (PICS)

[electricfurnace]

Fitted a small megane splitter which I got off ebay for £8. A doddle to fit, looks much better than the larger 307 splitter I had on it previously.

If anyone's after a small megane splitter I'd highly recommend tapping 'megane breaking' into ebay and messaging each asnd every seller asking for a splitter - bound to be some out there!

Pics! (Will get more pics of the car up ASAP, not enough room to take good shots on the drive!!)

 

[K1NGY]

Tastyyy

 

[jesus]

The small ones look spot on!

 

[electricfurnace]

thing is, they basically are already the same curve as the clios bumper, so a doddle to fit too! Very pleased! I think I even prefer it to the carbon KTec ones

 

[franx]

which year-make Megane mate ? ; i'm looking hard for a new one on the cup

 

[Ben]

How do you fit them mate? Looks great.

 

[nick.]

subtle but sweet great work

 

[iimushroomzii]

which year-make Megane mate ? ; i'm looking hard for a new one on the cup

Megane coupe's up to about 02-03 iirc.

 

[Craig.]

Ive just fitted one to the RB & it looks spot on, perfect for lowered cars as they wont just snap...you think they were made for the clio bumper they fit that good

They are off the ph2 meganes

 

[iimushroomzii]

So, If they fit so well to a clio, Would a clio carbon splitter fit my coupe?

 

[franx]

Ive just fitted one to the RB & it looks spot on, perfect for lowered cars as they wont just snap...you think they were made for the clio bumper they fit that good

They are off the ph2 meganes

ph2 Meganes , which years were they ?

 

[franx]

^^ just read Mushrooms post, nevermind

 

[Craig.]

So, If they fit so well to a clio, Would a clio carbon splitter fit my coupe?

No it wouldnt fit mate

 

[iimushroomzii]

Bum.

 

[electricfurnace]

The splitter was off the following car

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=330342259876&ssPageName=ADME:X:RTQ:GB:1123

2002 ph2 Megane

Fitted it by jacking car up one side at a time, started in the middle by offering splitter up to the bumper, drilling 2mm pilot holes through the splitter and into bottom of bumper, then used some small self tapping screws to screw it in, about 8 in all. Used a pair of pruning cutters (for plants!) to cut the excess edges off when it was on the car. Bit of bumper gel on it and voila!

hope that helps!

 

[SammyT]

looks spot on mate.

 

[WILLIE]

Very nice. Suits it well.