As you all know Clios most if not all have an athermic windscreens that block out GPS signals.
Now you can place your SATNAV at the bottom/middle of the windscreen which is not athermic. which is fine unless you have a large sized SATNAV and cradle or run TWO GPS items like ROAD ANGEL & SATNAV. (like me)
So I have created this guide, as I believe its the most reliable, quickest, cheapest and less hassle way of a "cure" to run 2 GPS items; OR if you just want your SATNAV in a better location. (imo) and it involves NO tools or NO panels, dash or items to be removed.
*This guide is for the Garmin i3 SATNAV but CAN be used for your own SATNAV with correct antenna!!
Problem...
Unable to run my sat nav AND road angel due to athermic windscreen.
Car...
Renaultsport Clio 182
Items owned...
Garmin i3 SATNAV , Roadangel 2.
Tools Required...
NONE!!
Firstly you will need to purchase a SATNAV antenna thats suitable for YOUR equipment. these will normally cost you between £7 and £30 dependant on your unit. I chose the offical GARMIN external antenna (GA25 MCX) which cost me £15. these can be baought from any good car electronic shops. this has the MCX connector which most SATNAVS have. luckily this is also the same as the ROAD ANGEL 2 so I could use it for that as well.
Right, here we go. Firstly place the antenna part here. just to the right of the back seat. I'm using double sided tape for this, Ive used closure plate tape I get from work, this is sticky to hold it, but is designed to be removed with no marks left. (im looking at alternative ways of securing)
a closer view.
Running the cable..
all you need are the tips of your fingers. this is where the build quality of the Clio comes into its own (lol) use the tip of your fingers to gently push the cable behind the plastic trim and the window.
Carry this trend on BEHIND the seat belt then down underneath the door rubber as pointed. again, only fingers needed.
And along the bottom door seal.
Carry on up the seal toward the front...
and then up between the side of the dash and the door seal... coming out about an inch as shown.
and then simply plug the antenna into your SATNAV as shown.....
The result.....
I've got pretty much a FULL signal all the time. I fitted this 4 weeks ago and its never dropped below 4 bars. and when you dont want to use your SATNAV just fold the cable back out the way.... like so... and remove your equipment.
Hope this helps someone. Any questions, ask me.
regards.
Nebdingo
Now you can place your SATNAV at the bottom/middle of the windscreen which is not athermic. which is fine unless you have a large sized SATNAV and cradle or run TWO GPS items like ROAD ANGEL & SATNAV. (like me)
So I have created this guide, as I believe its the most reliable, quickest, cheapest and less hassle way of a "cure" to run 2 GPS items; OR if you just want your SATNAV in a better location. (imo) and it involves NO tools or NO panels, dash or items to be removed.
*This guide is for the Garmin i3 SATNAV but CAN be used for your own SATNAV with correct antenna!!
Problem...
Unable to run my sat nav AND road angel due to athermic windscreen.
Car...
Renaultsport Clio 182
Items owned...
Garmin i3 SATNAV , Roadangel 2.
Tools Required...
NONE!!
Firstly you will need to purchase a SATNAV antenna thats suitable for YOUR equipment. these will normally cost you between £7 and £30 dependant on your unit. I chose the offical GARMIN external antenna (GA25 MCX) which cost me £15. these can be baought from any good car electronic shops. this has the MCX connector which most SATNAVS have. luckily this is also the same as the ROAD ANGEL 2 so I could use it for that as well.

Right, here we go. Firstly place the antenna part here. just to the right of the back seat. I'm using double sided tape for this, Ive used closure plate tape I get from work, this is sticky to hold it, but is designed to be removed with no marks left. (im looking at alternative ways of securing)

a closer view.

Running the cable..
all you need are the tips of your fingers. this is where the build quality of the Clio comes into its own (lol) use the tip of your fingers to gently push the cable behind the plastic trim and the window.

Carry this trend on BEHIND the seat belt then down underneath the door rubber as pointed. again, only fingers needed.


And along the bottom door seal.

Carry on up the seal toward the front...

and then up between the side of the dash and the door seal... coming out about an inch as shown.

and then simply plug the antenna into your SATNAV as shown.....

The result.....

I've got pretty much a FULL signal all the time. I fitted this 4 weeks ago and its never dropped below 4 bars. and when you dont want to use your SATNAV just fold the cable back out the way.... like so... and remove your equipment.

Hope this helps someone. Any questions, ask me.
regards.
Nebdingo
Last edited: