can anyone out there give me the measurement from the g/box bellhousing/block to the o/s inner wing ie how long an engine can be to go on original box and not foul the inner wing
also if anyone has a old valver/willy g/box hanging about could i have the bolt measurements ie the distance between the top two then the distance between the next etc see dodgy diagram below
0<-->0
0<----------->0
0<------->0
i know its bad and there is probably more bolts but its to give ya an idea of what i need
also if anyone has a flywheel of the same knocking about i need to know how many bolts hold it to the crank and what the diameter of the flywheel from the teeth one side to the teeth the other is
and finally the measurement from bulk head to front panel
as you can guess i wanna put a different engine in one and if these match or come close to what i have for the new unit ill buy a valver and go for it
many thanks in advance as this would be very much appreciated
chris
