Recent content by AndyT23

If stock tyres are 60 profile, then 55 profile will be lower not higher. I'd go for the 185/55/15, they're the same width and only slightly lower profile.

I used to have terrible running when cold and a lumpy idle on my cup, but things have improved significantly since buying a RSTuner and using Henk's latest files. The car runs much better throughout the rev range.

Thanks for the info. I am looking forward to getting it after seeing all the posts from people who have them. Sounds like it should give me exactly what I'm after.

I'm eagerly awaiting the arrival of my new RSTuner which I finally managed to get ordered at the weekend. I've been wondering about one thing... I've got a Pipercross Panel filter and a Magnex cat back system on the car at the moment, will the maps available for download from Fastchip be ok to...

I believe the oil pressure switches are quite prone to failing. Had to change mine a couple of months back. Cheap to buy and dead easy to fix, might be worth a try if you've checked all the obvious things.

Yep cliospares do them, about 35 quid from memory.

When I got mine off I could see they definitely needed doing. There wasn't far to go to the backing plate... :dead:

I've had exactly the same problem with my 172 Cup. Took it in for service and was told the pads were very low. I have to admit I hadn't checked them for a while given that I changed all pads and discs when I bought the car only 15k miles previously. I've changed the rear pads and when...

Mine dropped off at 22k!! 53 plate.

I posted in the quoted thread and I'm still not happy with my car now really. It has been checked out a couple of times now with nothing found. I'm still finding that a slight left/right movement of the steering wheel gives a very slight clunky sensation back. It hasn't got any more...

I would declare all mods. When declaring a panel filter I would probably state specifically to them that you have fitted a non-standard filter but that it makes no increase to the performance. Any minor mod like that which will only make small performance increases I would do the same for. The...

As a relative newbie on CS I had often wondered why lusty got so much stick from people.... Having seen page 1 of this thread all becomes clear!!!

That bracket is one beautiful piece of engineering, I'd quite happily sit it on my coffee table. :o I do a hell of a lot of work with precision machinists through my work and I know if I took drawings down to them for that fitting kit then it would definitely not be a small bill!! I guess if...

I think if you buy genuine renault parts from a dealer then they do come already pressed in. Buying them elsewhere they will come seperate.

I've been feeling a slight bit of play in mine over the last few months and have been checking different things for a couple of months to try track it down. I even had it into my local reno dealers (they are usually very good, rare I know!) and they didn't think it was anything to worry about...