abs

The car starts fine usually after 1 or 2 cranks however when driving and coming to a stop when pressing the clutch, the revs will dip ever so slightly. Setting off can be a pain too, it's like my clutch is on its way out even though it has just been replaced and then the car judders and I...

ABS light is on on my 1.2 2003 clio, apparently ABS rings. How hard are they to change? Thanks, Kieran

Where can i buy a OS rear ABS sensor from? for clio 172 phase 1 2001. thanks

Hey guys I know hardly anything about cars... Thought I'd come here I own a 2003 Clio 1.2 16v dynamique ... And recently I had abs dash light on Plugged it to a putter and it told me is my driver side sensor... That reading cost me money already :( Now budget run out.. I've bought a second...

Just a quick one, I have the brake pedal fart as it seems to be named on here and would like to have a look at the suspected abs rings to see if they are the problem. Where are they located? Can I jack the car up to be able to see them or does it need the wheel, discs removing?

It would appear that someone previously has fitted an incorrect drive shaft to the off side, the ABS Ring is a different diameter to N/S and as a result the ABS kicks in as the car draws to a complete halt. Apparently shafts are no longer available? Anyone have a source or thoughts? Cheers John

I fitted my new snappy wheel today all fitted fine. Went to go for a drive and the serv and esp light came on. Car drives fine. Got home switched engine off and then back on to move car into garage and now the abs light is on too Any ideas??

just wondering if anyone knew a price on rear abs sensors for a 1.6 with discs/dci 100 i have messaged Adam from Wolverhampton but he hasn't seemed to pick up messages over the last few days and with winter kicking in best to get them done asap thanks

Morning all as some of you know I was given a 2005 Clio with 152,000 on the clock. (first car for misses) I have overhauled lots of it like, Clutch, bearing, clutch cable, gearbox oil change, cleaned all engine earths, cleaned abs rings / sensors, oil / oil filter change, air filter, Ing pack...

Can someone help me out, the abs light is always on in my clio mk2 so I took it to a garage so they could do a diagnostics on it, they said there was a problem with the pump and it needed to be replaced and they said if I was to buy one myself I would have to make sure the part numbers match so...

apparently there is no real way of removing them in one piece, so i'm resigned to getting two new ones for my roll centre kit. What I was wondering about, why is the sensor fit so tight? It is held on with a small bolt anyway. I was thinking about enlarging the hole so it would still be a...

I have a 172 cup which has an intermitent fault where our revs are limited to around 6200-6500 and the ABS & Service lights come on. I have fitted a new stat and water sensor and of course being a Cup it doesnt have ABS. We have tried all the connections but it just comes and goes. Any ideas ?

Ive been looking around for the best way to plumb my brakes up with copper pipe on my 182. Have I got the right idea with this..? Keeping the 182 master cylinder with 2 outputs. 3/16 copper pipe coming out the front output then split via a T piece and run those 2 pipes straight to the front...

hi guys got a feeling my ABS rings have cracked no abs light but at speeds about 0-20mph sometimes feels like the abs kicks in seems to happen more when iv left the car for a few days how easy are they to replace or anyone in essex fancy giving me a hand ? cheers

looking to refresh my suspension, currently std shocks with eibach springs. searched on here and it seems I can put the slightly updated 172 cup shocks on my non cup 172.. can anybody with experience confirm? as I see in a couple of threads people also say they don't?? which is it, a yes or a...

Going to look at a clio 172 on friday but he told me the ABS light comes on after about half a mile and need to buy a ABS sensor. I asked him which one i need or tried to find more information about it and he does not know. He just said it will cost 25quid for part. Is this costly? In labour or...

I removed my ABS a while ago but one of the plugs is still connected. The smallest plug is the ABS sensor in the hub, the big plug is to the ABS module. The middle sized one is still connected but I don't know if this goes somewhere where its not needed. The wires one the plug pictured are green...

Does anybody know how many teeth are on the abs rings on a clio 1.2 16v dynamique 2003

Hello im in need of help since fitting new discs and pads on my clio 197 cup the esp light and the abs light and service light are on I read someone's post saying on his it was the ecu Picking up brake fluid pressure before brake fluid switch had been trigered how do i fix this , please help...

Afternoon, Got a cracked ABS ring causing the ABS to be a little bit funky under low pressure, low speed braking. Off to the 'ring next week and should probably fix it before I go. I've found them on GSF and was told by Feirny that ECP do them, but can't see them on ECP's website. Anyone...

Just bought a 182 Cup (my third 172/182 over the years), very happy with it but sometimes while driving the SERV, ABS and traction control lights all come on at once, car still drives fine and when I next start it lights are off, any ideas? It has much modified suspension, an RS Tuner 98RON...

Hi, I'm a new member of this forum. I'm changing the rear dampers on my recently bought Clio 172. I bought Monroe absorbers to replace them, but one upper nut is missing in the box :S. I believe it needs a M9x100 nut. The nut currently fitted are not the same, probably due to the fact that's...

Hi i have a clio 182 with cup pack. The traction control light is up and it says service. I assume this is a ABS ring probably cracked?? What number of teeth does it have on it and is it wider than the standard one. Unable to jack car up at the moment to check. Thanks, Mark

Hi all Managed to source a second hand ABS pump, what's the best method to replace / bleed system. I've heard that you need to prime pump first and jump the relays to turn pump on while bleeding has anyone done one of these before? as I was just going to fit and do the two person bleed (one in...

Hi all I'm trying to source an ABS pump but everyone I'm messaging are stating an 0265 module number which mine don't have how will I obtain this? I get bad vibration through the brake pedal under braking and only brake pedal, I have cleaned the sensors and ABS rings and still there, one of...

Hey Need some advice. Is there a guide on how to remove a Front passenger shock absorber and then replace it with a new one? Mine needs replacing as the chap who did my MOT said he could lift it with a bar very easy when other side was stiff. Thanks all

My 182 cup has developed an ABS fault I am trying to fix. The serv, abs and brake light will come on while driving (not braking) and will stay on. Occasionally there is juddering in the pedal. If the car is left a few days the lights clear. The rings have been checked and look fine, the...

Does anyone know if it's 26 or 44 teeth on the front rings for a Ph1 172 and does it matter if I have 44 on the rear but 26 on the front rings? Thanks

These lights come when I'm driving quickly and take a sharp left turn. As soon as I stop and turn the car off, they stay on for about five seconds after the other lights have gone out but then they go out as well. They never come on otherwise at any speed or if turning right. I've plugged in a...

Hello, I have recently had a problem with my ABS, it was kicking in when I was slowing down and juddering all the time. I wasn't sure what the problem was, however I was changing the ball joints on my car the other day when I seen that one of the ABS rings had cracked and I pulled it off, it is...