Im building my own 172 turbo using a gt28rs and im coming near to the end of it all now, to prime my turbo am I right in the following;
squirt a little bit of oil into the oil feed and spin turbine by hand and connect oil feed up
disconnect coil pack
fuel pump relays removed
return pipe disconnected at sump
crank over for 5-10 secs until I get a good flow of oil out of the return pipe
And can i also use the return line from the thermostat plumbed into the lowest water port and another pie exiting from highest water port and back into header tank, would this be sufficient enough?
Cheers
Pete
squirt a little bit of oil into the oil feed and spin turbine by hand and connect oil feed up
disconnect coil pack
fuel pump relays removed
return pipe disconnected at sump
crank over for 5-10 secs until I get a good flow of oil out of the return pipe
And can i also use the return line from the thermostat plumbed into the lowest water port and another pie exiting from highest water port and back into header tank, would this be sufficient enough?
Cheers
Pete