BMW paint is hard?

[Turner]

Just done my mates blue 323 convertable boot lid and started with menz i.p on white 4in sfx pad with G220 didnt touch it after a couple attempts so stepped up to yellow sfx pad and after 2 attempts with that was a big improvement but still only prob 70% correction
Is it really hard paint or am i doing somethng wrong etc?

 

[Tez.]

whos that bird in your av ???

shes f**king mint

 

[Bullit.]

aim to do smaller areas,12"x12", bit more pressure. then wip out the power gloss

 

[Rich]

Nightmare to correct by DA alone. As above work in small areas and be prepared to repeat the area a few times.

 

[Turner]

whos that bird in your av ???

shes f**king mint

lol its my mrs of 6yrs matey

 

[Turner]

Nightmare to correct by DA alone. As above work in small areas and be prepared to repeat the area a few times.

that as much i did break his boot down into small pieces like i did 5 sections on the boot nd used quite a bit of pressure even on speed 6 and movin an inch a second
think i could prob get 85% of them out with a second full attempt maybe working in even smaller portions
fook doing a whole BMW thou,youd be there all week to do it properly

 

[Michael172]

Took me 7 hours to cover a merc with Menz compunding stuff.

 

[SBV116]

We did a bmw 1 series, was a f**king nightmare! well, gaz did most of it to be honest..... took a full day, and it wasn't very old!

 

[JMR]

Straight to the point Adam, YES ITS HARD!

Spent a day and a half doing a Z4, though it was full correction all round and fabric hood needed quite a bit of attention, went down to IP on a yellow 4" pad, then final finish one white.

Great improvements;

Before

After

But hard work.:dapprove:

 

[Rich]

Great work ^^^^