HELP ME!!!! 197 exhaust standard to ktec pro

[TomsF1]

Iv got to the point where everything is off on my exhaust and now it's just a case of sliding the standard exhaust off. Do you have to cut it to get it over the rear beam or??? Please get back to me ASAP thanks Tom.

 

[Knuckles]

Lower the rear beam? Someone did it with an akra exhaust

 

[TomsF1]

How the bloody hell do I do that lol

 

[rbrocky]

Jack car up, remove two bolts that hold the bottom of the shock to the rear beam. rear beam will now fall.
Keep it in this position (Maybe remove springs)

Et Voila...

 

[TomsF1]

Really you actually got to drop the beam? So much for a slide on easy fit exhaust eh?

 

[rbrocky]

Its not too hard mate, literally two bolts! It will help if you put a jack underneath it, as the beam will just fall other wise. then slowly release the jack. This will be the same but in reverse for refitting.

 

[Knuckles]

You're quite handy aren't you rbrocky lol... I have no idea how to drop the rear beam... I just know it helps

 

[rbrocky]

I do like to try my friend!

 

[Knuckles]

Me too... But I'd probably do more damage than good

 

[Carbonraider]

Not as easy as that bud.. To avoid damaging the car jack the rear up.. Axle stands on jacking points.. Remove the 2 damper bolts... Remove the 3 bolts on the drivers side ( holds the beam to the car) make sure before hand you unclip your abs wires... Exhaust will slide off in 1 piece.. Bolt beam back to car... Jack beam up bolt dampers back in... Starting from manifold assemble exhaust only nipping clamps.. Final fit everything... Tighten up all clamps... Diffuser back on... Lower down to floor and start up... Finito took me about an hour on the floor.

 

[TomsF1]

I started at 3 lol just putting it back on now thanks for your help though guys