Mertin
ClioSport Club Member
Ph1 172&Ph2 172 Cup
What setup is everyone using for a throttle cable when running ITB's?
I have a Ph1 so cable throttle already however id rather fit a readily available cable so I ordered a Jenvey cable. Also got a few linkage's so hopefully can mount it to the pedal ok. Does it need to run in the standard sheath and all the gubbings that goes with it?
I got a cable from PMS however it doesnt have the 'pill' on the end so ordered some of these aswell as an option however its just an aftermarket cable.
My options below
1. Install jenvey cable (my preferred if it will work)
2. Retain ph1 cable and trim the sheath to suit, rather not do this.
3. Use the PMS supplied one
I have a Ph1 so cable throttle already however id rather fit a readily available cable so I ordered a Jenvey cable. Also got a few linkage's so hopefully can mount it to the pedal ok. Does it need to run in the standard sheath and all the gubbings that goes with it?
I got a cable from PMS however it doesnt have the 'pill' on the end so ordered some of these aswell as an option however its just an aftermarket cable.
My options below
1. Install jenvey cable (my preferred if it will work)
2. Retain ph1 cable and trim the sheath to suit, rather not do this.
3. Use the PMS supplied one
