Lacquer help

[Vern]

ok i have just done my badges blue with orange 2.0 to match my orange diamond whilst on the final stage (Lacquer) on one of the badges the can spat a little and have a slight small bubble on it

question is can i sand this out using p1200 wet & dry without buggering it all

i have 3 layers of lacquer in total and its the top coat that has this slight bubble

any help would be great cheers

 

[Renault_Boy01]

if you sand the laquer LIGHTLY then you might get away with it..

if you sand it to hard you will take it back to the paint and then you will ruin it

 

[Renault_Boy01]

just remeber to spray another coat over the top if you do sand it down

 

[Vern]

i might just leave it dont know if i want to risk it it seriously a small small bit so might just leave it lol

 

[Vern]

Changed my mind and went against my own judgement wet sanded using p1200 wend dull and patchy, needless to say i panicked lol
but resprayed a layer of lacquer and bingo perfect Cheers for the advice Mate

 

[Renault_Boy01]

glad to hear it

 

[Final Maxim]

could have just polished it up if you had any cutting compound, but tbh polishing with P1200 is a little risky unless it was rougher than a dogs arse