Damn site better than you left yours.
Still a sore subject.
Damn site better than you left yours.
Looks a bit sh*t.
Good plan's, have you seen the set of billies in the for sale section?
Above the rear lights are some black grommets. If you can spin them with your fingers they're fcuked so either silicone or new grommets. I've had to do a couple of them in the past. Worth checking.
Had an almighty rainstorm earlier .. Checked the boot once it stopped raining and it appeared to be dry !
Fingers crossed............... :quiet:
It has beguned.
Arriving this week:
- Fresh plates - proper size.
- Velcro x1m of for plates.
- Saxo washer jets (mist-type).
- Paint cans for some resprayz.
- Microphone for the BT HU.
Arriving at some point in the future:
- Bilsteins.
- Matched inlets.
Other stuff I want:
- Seat runners for drivers seat (anyone?).
- More induction noise but standard airbox.
- Cupra R splitter.
Sounds good to me, Mark
Not bring it to Bedford then rob?
Or just buy my ticket mate. Then you can run both!!
I do like this car, that rear bumper though. Its honeslty the same colour as a civic jordan.
Its shocking tbh @Craig. I mean its a clean car, but its not mint as so many people thought. Not that I can talk as my cars are always sheds!
Be alright with the cup wishbones and spacers as long as there are no arch liners fitted, my flamer ran AST top mounts set with full castor and 25mm spacers and williams wheels (higher offset) and was fine.
I was planning on removing the arch liners for track TBH
Bit of extra room and also a bit more air flow to the brakes !
Can't get it to scrub yet when in full combat roundabout attack mode... so we'll see...