Removal of Stubborn Brake Disk (182)

[AliasOmega]

How do you get it off, undo the T35 bolts and it just wont move. Tried a hammer, and still sits nice and tight.

Advise.?

 

[ben_p]

front?

 

[AliasOmega]

front right..

front left come off nice..

 

[ben_p]

wd40.. and smack it with a hammer either side untill is pops off

 

[AliasOmega]

Did hit it with a hammer, just sat still..

left was a little corroded in the join..

shall try again with a rubber mallet.

 

[makavelli]

as ben said take a mallet and whack the fooker

 

[bigmonmulgrew]

You have to make sure your whacking it evenly on either side or it will just get tighter

 

[Sami]

Are you putting a new disk on afterwards? If so just smack it with a big hammer, otherwise just keep smacking it round with a rubber mallet.

 

[T31-SGB PH-QUICK]

bigger hammer!!!

 

[Simf40]

i usually get a centre punch and hit the middel of the gold torx bolts which hold the disk on,
that then loosens them and if that still doesn't come off then hit the bolts with a centre punch on the outside then you can hit them off? hope that helps

 

[msa197]

Hit the dics from the back, when turning it, if you hit it in the same position say 12 o'clock, 3o'clock, 6 o'clock and 9 o'clock. given time it will come off.