Harlow Motorsport mk1 cup racer

[Williamspaul]

New cambelt kit and poetess and painted inlets engines almost ready to go back in now

 

[Williamspaul]

Ported and painted *

 

[Williamspaul]

Thinking about making a bulkhead here and putting the air filter on the other side of it to give it a cold air feed

 

[Williamspaul]

Key’d crank pulley and paddle clutch

 

[Williamspaul]

I’ve finally started the underneath stripping back the old stone chipped paint with a wire wheel

 

[Williamspaul]

Tidied up the rear panel behind the bumper and left it in primer for now

 

[Williamspaul]

Bare metal boot floor and in primer

 

[Williamspaul]

Bit more progress

 

[Williamspaul]

Osr inner wheel arch in primer

 

[Williamspaul]

This job is exceptionally tedious and so dirty and dusty it’s horrible under there but I’m making good progress this is on top of where the fuel tank sits under the rear seats

 

[16V F7R]

Nice job you are doing. Did you have all that rubbery factory under seal to take off? If so what was best to get that off?

 

[Williamspaul]

Nice job you are doing. Did you have all that rubbery factory under seal to take off? If so what was best to get that off?

I was quite lucky I think that was all removed when it was new I assume to make it lighter and has been painted underneath