Search results

Any idea what fitting adapter I'll need for the C120? I'm not near mine to check it

Thanks chaps, I'll have a look at the suggestions

Has anyone used these Nilfisk snowfoam lances and is it any good? I've got a Nilfisk C120 (I think) and have never delved into snowfoam as yet.

That looks like mine before I hit it with a knotted wheel, be prepared for the rust to have gone a lot further than you think/hope. Mine had holed the top of the arch in a small area.

Seen this car again in and around Herefordshire

Bloody good point Russ!

Ah good point @Brigsy just that I don't have clip😪

I just got one of the kids to hold a spanner on the inside while I spun the nyloc nuts on correct torque.

I would do but want to be able to back to standard for anal MOTers, living where I do I'm not blessed with a huge choice without long journeys

Yeah they sent me that too, seems an absolute bodge to me. Surely for the cost of their resistors they should just have thicker pins.

Yeah don't waste your money on Renault bolts unless you are extremely anal

Needs a clean that! 😉

I've thought this too and nearly didn't do it, it then dawned on me that I have a motorbike so Volantec steering wheel it was! I can't decide whether to add a Renaultsport sticker?

I can drag my less than perfect (character I call it) flamer along.

Would that even fit under a 172 or 182? On standard suspension maybe but few are now

Have you tried a bit of 1500 grit super glued to a thin strip of wood to clean up all the pins in the 'white plug of doom'? Pack it full of silicone grease on reassembly. Solved mine after months of hassle.

Kington, just over the border but so close to great roads, Rhayader etc

@SharpyClio I have a 182 cc wheel if needed

Yes you can make cruise buttons fit a non cruise wheel, just need to trim a bit of the inner foam like material to fit and use a cc airbag ideally.

I used a 4 pint milk bottle to make a rain shield for my wiper mechanism, I've got photos somewhere

Do aqua blasted alloy parts need lacquering or anything to stop them corroding afterwards? Top work!

Those look exactly like the ones Volantech supplied to be honest

Spotted yesterday as I was coming over the Bridge at Bredwardine, very clean considering the roads around there.

I've fitted a volantech steering wheel and their airbag resistors which were very loose so I wrapped them in insulation tape to keep them in. I'm getting sporadic airbag and SERV light popping up, is this likely just because of the poor fitting resistors?

Kappa trackies?

Good progress, I've always wondered why the front seat rail support for the passenger side seat is painted black on 172/182s. Anything to do with being seen if the autochanger or seat storage isn't fitted.

That looks incredible, I dred to think how much that cost with the attention to detail- disassembling door handles!

I snapped my release cable, you can just about get to the release mechanism through the grille area if you remove the bumper which is possible without the bonnet up. May not seem it but with a bit of patience it will work.

I'm still too tight to buy them, I bought originals for my old 182 when you could get them for around £6, not paying nearly £20

Ah OK, I did wonder that! Cheers mate