Bucket Fitting

[mas]

ok, got me some bucket seats today, mk1 subframes, which apparently bolt on to the original sliders.... how the hell do i get the top of the seat off so just have the slider to bolt it too???

just cant see what to undoe etc...?

thanks

any other tips on fitting, pre tensioner shiz n stuff

 

[dumpy]

I have corbeau recliners - which will be same fitting idea as buckets!!

Bassically you have to take the whole seat and frames out then decifier your way through after that!!

There are 2 bolts which attache under the car (on each seat) which is in where the exhaust runs - if i remember right its just to the back of the cat - these are the most difficult to get off awkward - ideally need 2 people because there is a nut on the top and bottom of the bolt to take it out!!

Have you got after market subframes??

HTH,

Dumpy

 

[mas]

sweet, managed to fit them all sweet, any pics of where to mount the harnesses in mk1's... the side bits seem loose, even when you tighten it full.