how to wire dual voice coil sub

[jarvis *RT*]

got a 15 kicker.wanted to know best way to wire it up. could it be wired to a 4 channel amp?

 

[Bryan]

it can, but it all depends on the amp, its all down to power figures at different resistance levels

 

[Tom]

you have to be very careful with it tho. if the amp isnt balanced the sub will f**k itself

 

[ChavyBoy]

If your amp supports 2 ohm or 1 ohm load you just connect both connections into 1 channel. If you Amp supports bridging mode then bridge it and run both connections into 1 channel, but you must be able to run 2/1 ohm load into you amp to do this otherwise youll screw the amp/sub.

There is alot more to this but this is a basic setup.

 

[Colin_S]

very very few amps can run at a load of under 4 ohms when bridged. DO NOT run both coils to a bridged channel or youll feck your amp.

If you are buying an amp for it, get a mono channel