valver rear brake pad question

[sleepy]

OK following on from an earlier thread, i have had a few difficulties trying to change rear brake pads on my 1.8 16v 1991 clio .

Basically the rear outer pads are secured to the caliper with 2 screws but i went to halfords and both the ferodo pads and halfords own brand pads do not have the two holes in the brake pads for the two screws to secure into.

Why is this, what the devil is going on?

anyone else noticed this problem.

Need help asap

 

[Matbrown]

They are not needed, since these pads fit a number of cars and only renault put the screws in, the aftermarket ones don't come with them.



Mat.

 

[Lunner]

My calipers on my car don't even have the screws on them as std, as mat said, not needed

 

[sleepy]

ok thanks for advice. In the end I ended up getting a set of lucas pads which come with the bolt holes but are about £8 more expensive than the ferodos.

My next problem is that i cant remember how the spring goes back on the pads. I thought i had it sussed but the damn springs wont fit right. I dont suppose anyone has a close up picture of there rear brakes.